Dimensions of the load is one of the topics in the General rules block of the Spanish DGT theory. Defines who the traffic rules apply to and where, the basic definitions and the principles behind the whole theory. Understanding this section well helps you answer the theory-exam questions on this topic with confidence.
In practice, this comes down to the following:
- In the case of beams, posts, tubes or other loads of indivisible length:
- If the smallest dimension of the indivisible load is greater than the width of the vehicle, it may protrude up to 0.40 metres on each side, provided that the total width is not greater than 2.55 metres.
In short, the rule makes sure every road user knows what to expect in this situation.
The exam often asks where and to whom these rules apply; read the options carefully, as they frequently change a single word.
In vehicles intended exclusively for the transport of goods, in the case of indivisible loads and provided that the conditions established for their stowage and conditioning are met, the following may be included:
- In the case of beams, posts, tubes or other loads of indivisible length:
- In vehicles longer than five metres, two metres at the front and three metres at the rear.
- In vehicles with a length equal to or less than five metres, one third of the length of the vehicle at each front and rear end.
- If the smallest dimension of the indivisible load is greater than the width of the vehicle, it may protrude up to 0.40 metres on each side, provided that the total width is not greater than 2.55 metres.
❓ Frequently asked questions
What is dimensions of the load?
Does this topic appear in the DGT theory exam?
Where is it regulated (Article 15 (2))?
🚦 Practise with DGT tests
Already studied the theory? Test yourself with official exam-style questions.
📝 Start with TraficoTest